Introducing the new standard: adjust the angle of the bike from the wall to maximize space. Reduces the bulk of your bike by getting it closer to the wall.
Safety issue (rubber grips deteriorate over time, allowing bike to fall) I bought this rack almost two years ago (Feb 2016). When I installed the rack it seemed solid and well built, and I loved that I could hang my wife’s bike in a way that the bike was horizontal, which made it much easier to put up and take down. However, a few months ago I woke up to a crash in the garage. The rubber grips on the end of the rack had come loose and the bike was on the floor. I pushed them back on fully and while I was concerned, didn’t worry too much about it. However, since then…
Apparently a good idea, but not really. Please read… The rubber thingies that hold the bike are very flimsy, and are almost sure to eventually fail if you install it as shown in the picture, with one arm higher than the other. When you do that, the perpendicular angle of the bike’s horizontal bar pushes/bends the rubber holder to the side. This causes your bike to be resting not on the V shaped opening at the top of the rubber piece, but on the side, which means there is only a small piece of rubber standing between your bike frame, and a very…
TERRA PEAK Hydration Bladder 2 Liter Leak Proof Water Reservoir, Military Water Storage Bladder Bag, BPA Free Hydration Pack Replacement, for Hiking Biking Climbing Cycling Running Black
ZXTDR Kids Full Body Armor Protective Gear Jackets Children Mesh Clothing for Motorcycle Motocross Dirt Bike Racing Sports ATV Safety Guard Armored Protector Black (S)
Lucky-M Kids Outdoor Sports Protective Gear ,Boys and Girls Safety Pads Set [Helmet ,Knee&Elbow Pads and Wrist Guards] for Roller, Scooter, Skateboard, Bicycle(4-8 Years Old)(Pink)
Great storage…
Safety issue (rubber grips deteriorate over time, allowing bike to fall) I bought this rack almost two years ago (Feb 2016). When I installed the rack it seemed solid and well built, and I loved that I could hang my wife’s bike in a way that the bike was horizontal, which made it much easier to put up and take down. However, a few months ago I woke up to a crash in the garage. The rubber grips on the end of the rack had come loose and the bike was on the floor. I pushed them back on fully and while I was concerned, didn’t worry too much about it. However, since then…
Apparently a good idea, but not really. Please read… The rubber thingies that hold the bike are very flimsy, and are almost sure to eventually fail if you install it as shown in the picture, with one arm higher than the other. When you do that, the perpendicular angle of the bike’s horizontal bar pushes/bends the rubber holder to the side. This causes your bike to be resting not on the V shaped opening at the top of the rubber piece, but on the side, which means there is only a small piece of rubber standing between your bike frame, and a very…