LEXIN Motorcycle/Bike/motorbike Metal Cup Holder Handlebar Drink Cup Holder with Basket
Feature:
Highly Chromed with a 360 Deg. Swivel allowing you to install in your desired location.
This “ring” style drink holder is easy to install.
The Basket is a snap design that is also collapsible for storage.
This is a great way to carry all of your drinks. Large enough to carry about anything you want.
Fits 7/8″, 1″ & 1 1/4″ Handlebars.
Notes: Cup Holder Drink Ring Inside Diameter: 3.50″
The Ring comes off in Seconds allowing you to just leave the Handlebar
Mount installed on your bike when you do not want the ring on the bike.
Includes different size Bushings allowing you to install this on different size bars.
Package Includes: 1 x Motorcycle Cup Holder
Product Features
- This is a high quality piece that looks great on the bike, There is a hard plastic disc in the bottom so it won’t sag below a certain place. It’s all metal with an included allen wrench and three plastic sleeves to match your handle bar diameter. The “sack” unbuttons to clean it out easily
- Best cup holder I had, so far. This is solid, just don’t over tighten screws.use Locktite on threads and a winding or two of duct tape on handle bar. Then install the provided plastic spacer, depending on your handlebar diameter.
- The simply designed chrome ring blends in nicely with the handlebars with the black basket goes almost unnoticed. It is definitely not bulky looking, but yet it will hold a large travel mug/bottle.
- Highly Chromed with a 360 Deg. Swivel allowing you to install in your desired location.This “ring” style drink holder is easy to install.
- The Basket is a snap design that is also collapsible for storage.This is a great way to carry all of your drinks. Large enough to carry about anything you want.Fits 7/8″, 1″ & 1 1/4″ Handlebars.
I compared voltage readings with my Fluke and found that all of these read about 1-2 tenths of a volt low which for checking an A month and half later, So far this has been a waste of money. I am still unable to stop the clamp from turning down on the handlebars. I tried using super glue which won’t stick to the rubber and I tried putting tape between the layers and handlebar. (Reduced from 4 star to 1 star).Not too bad, but still sloppy made. The part that attaches to the handlebars is huge and requires two rubber inserts to fit my 1 inch bar. The rubber sleeves swell out of the clamp when tightening down…